Movement

Available in the Gaming Circle and Industries Circle

Move step

Following equation is used to calculate desired position delta for single move step:

Dynamic Velocity

• Velocity that accumulates external forces
• Gravity, impulse from explosion, force field, jump pad
• Can push the KCC upwards on slopes
• Related API when using default EnvironmentProcessor:
  • KCCData.DynamicVelocity
  • KCC.SetDynamicVelocity()
  • KCC.AddExternalForce()
  • KCC.AddExternalImpulse()
  • KCC.Jump()

Kinematic Velocity

• Unconstrained velocity calculated from user input actions
• Usually based on KCCData.InputDirection (entry point)
• Only walkable surfaces push the KCC upwards to prevent artifacts on steep slopes (controlled by KCCData.MaxGroundAngle)
• Related API when using default EnvironmentProcessor:
  • KCCData.KinematicVelocity
  • KCC.SetInputDirection()
  • KCC.SetKinematicDirection()
  • KCC.SetKinematicSpeed()
  • KCC.SetKinematicVelocity()

External Delta

• Absolute position offset
• Useful for corrections on the end of move step (after depenetration)
• Related API:
  • KCCData.ExternalDelta
  • KCC.SetExternalDelta()

Movement algorithm

The KCC virtual capsule always moves by calculated position delta and then depenetrates from overlapping colliders.

• ✅ This approach gives natural sliding against geometry.
• ✅ Most of the time single capsule overlap is needed which makes KCC very performant.
• ❌ Sometimes it results in jitter when moving against multiple colliders (usually some corners), but this can be usually resolved by running more depenetration steps.

Continuous Collision Detection (CCD)

If the character moves too fast (position delta for single step is bigger than 75% or radius), the movement is divided into sub-steps to not pass through geometry.

• Movement is divided to smaller steps based on desired velocity.
• The maximum distance traveled in single step is 25-75% of radius and is controlled by CCD Radius Multiplier property in KCC Settings asset.
• 75% is good in most cases, lower this value only if you have problems with KCC running through geometry.
• Before lowering CCD Radius Multiplier try to increase Max Penetration Steps (improves quality of depenetration) in KCC Settings asset.

Collision filtering

• Primary filter is collision layer mask - controlled by Collision Layer Mask property in KCC Settings asset. The Layer Collision Matrix from Physics Settings is not used by KCC.
• It is possible to explicitly ignore a static collider or an entity with KCC.SetIgnoreCollider().
• Use KCCContext.PrepareUserContext() to set ResolveCollision delegate for application of additional filtering rules.